Nissan
Jet Performance 69138 Features:
The JET Powr-Flo Mass Air Sensor delivers improved horsepower, torque and mileage from your car, truck or SUV by simply replacing the restrictive stock mass air sensor. The factory sensor not only is a major restrictive point in stock intake systems, but it also limits the full potential of aftermarket cold air intake systems. The flow bench tested design of the JET Mass Air Sensor provides airflow increases of up to 45 percent and installs in 10 minutes or less. Compatible with other aftermarket upgrades such as computer upgrades, cold air intakes, TBI spacers, free f low exhaust systems, etc.- Increase Horsepower And Low End Torque
- Improved Mileage
- Simple 10 Minute Installation
- No Other Vehicle Modifications Required
- Optimizes Cold Air Intakes
- Compatible With Other Aftermarket Upgrades
Specifications:
Will this properly fit my 2005 g35 coupe , engine vq35de ?
Will this fit a 2013 Nissan Frontier 2.5 four cylinder?
Will this fit 2010 infinit g37x sedan 3.7 engine
Hey can I use the jet maf for a 2014 q50 3.7? I installed aem air intakes and the mafs went bad twice, any suggestions?
2018 nissan frontier SV 4.0 L V6 someone had change the air intake to a k&n cold air intake will this work on this truck. Sensor I have is not cold air tuned so it keep messing up
Will this air flow sensor give me better response than the stock sensor that came with the car 2010 Nissan Sentra
Does it fit on the Nissan Titan 5.6L SE 2007?
Motor Vehicles
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
Tools:
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
Electrical Cords
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.