Items You Need
Base Engine
Engine Specifications
Power Ratings:
- Horsepower: 465 @ 5500 RPM
- Torque: 494 lb/ft @ 4400 RPM
Block Information:
- Seasoned OE Magnum block
- 4.040 in. Bore
- 2-bolt main
- 2-piece rear main seal
- Square and parallel decked
- Cylinders sonic tested and honed to with .0002 in. straightness and roundness
- Main bearing bores align honed
- Equipped with mechanical fuel pump provision
- Displacement: 408 cubic inch
Rotating Assembly:
- Crankshaft: Cast steel 4 in. Stroke
- Balance: External, 1993-1997 Magnum 360 balancer, Pre-magnum weighted 360
- Rods: OEM type 6.123 in. Length with 150,000 psi bolts
- Compression Ratio: 10:1
- Pistons: Forged
- Rings: Moly
Camshaft Specs:
- Camshaft: Hydraulic roller
- Cam Duration @ .050 in.: Intake 235 / Exhaust 242
- Cam Lift: Intake .580 in. / Exhaust .577 in.
- Lobe Separation Angle: 110
Cylinder Head Information:
- Cylinder Heads: Aluminum Magnum pattern
- Combustion Chamber: 58 cc
- Valve Size: 2.020 in. Intake / 1.600 in. Exhaust
- Runner Volume: 176 cc Intake / 75 cc Exhaust
- Roller Rocker Arms
Long Block Includes
- Short Block w/brass freeze plugs
- Camshaft
- Timing Set
- Cylinder Heads
- Valve Covers
- Timing Cover
- Oil Pan
- Oil Pump & Pickup Tube
Notes
- Not for use in pollution controlled vehicles
- Requires Magnum patterned intake manifold
- Dyno tested with dual-plane aluminum intake
- Spark Plug Gap: .045 in.
- Fuel Octane: Minimum of 91
- Stall Converter: 2000-2400 RPM
- Initial Timing: 10-16 Degrees
- Total Timing: 32-34 Degrees
Engine Break-In Procedure
Use or break-in oil or conventional (non-synthetic) 10w30 oil with zinc additive for the first 500 miles of operation. Do not drive for long periods at any single speed, always vary your speed. Do not tow a trailer or put other heavy loads on the vehicle. It is best to avoid long periods of idling during this period. Check the engine oil and coolant levels daily.
At 500 Miles change the engine oil and filter using conventional (non-synthetic) oil with a zinc additive. Check fuel and ignition settings, adjust valves (where applicable). Drive the next 500 miles normally, without high RPM's (below 5000 RPM), hard use, or extended periods of high loading or long periods of idling.
Change the oil and oil filter again at 1,000 miles. Continue using conventional (non-synthetic) oils and zinc additive, until about 4,000 miles. At that point, you may run a quality 10w30 synthetic oil if you choose. The use of oil with zinc or a zinc additive for the life of your engine is recommended.
Emissions Note:
This part is only legal for sale and use on Uncontrolled (Non-Emissions Controlled) Vehicles or on vehicles used solely for the purposes of closed competition racing.
CLICK THIS LINK FOR IMPORTANT CARB & EPA EMISSIONS INFORMATION ABOUT THIS PART
Specifications:
Motor Vehicles
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
Tools:
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
Electrical Cords
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.